Door Bottom Seal Concealed Type 1000mm Dust-proof Acoutic Door
Seals
It is installed in the bottom of the door leaf, when the door is
closed, the sealing strips is press down the ground automatically
to seal the gap between the bottom of the door and the ground, when
the door is open, the sealing strips will automatically retract
from the ground and will not affect the open and close of the door,
and will not damage the ground, the hidden installation does not
affect the appearance of the door, after installing the door bottom
seals, it can effectively prevent dust, insects, hot and cold air,
noise, and light entering through the door bottom gap, indoors, to
protect the indoor environment, it is an excellent accessory
product for hotels, markets, and industrial doos.
Features:
A. BH-M001 be used for wind-proof, dust proof and keeping bugs
outside.
When the door opened, the hermetic seal will rise up and leave the
floor.
When the door closed, the frame presses the nut at the end of seal,
it will fall down to floor tightly.
B. Properly distance between door and floor :3-14mm
C. Length: 1000mm ( could be cut to 900mm). Special size is
available.
D. Material :the rubber which is acid-proof, alkali-proof,
cold-proof, hight-temperature endurable and anti-aging.
Installation instruction:
Step 1. Make sure the install direction. The end with copper bolt
is near to the frame with hinges and the hermetic seal face to
floor.
Step 2. Make sure the bottom seal length can fit the door:
The length of BH-M001 bottom seal should be 3-5mm shorter than
width of the door if need to make the side plates implant of the
door leaf. If not, the length should be same as the door width.
Step3. According to the frame and door size, cut the end without
copper bolt to get the proper length.
Step4. Adjust : After installation. Open the door and turn on the
copper bolt out or in to adjust the drop down parts to touch the
floor slightly when the door closed.
Note: if there are too few ejections, the sealing effect cannot be
reached; If there are too many ejections, it is easy to scratch
with the floor and damaged the seals when closing the door, so it
needs to be repeatedly adjusted to achieve the best sealing effect.
Specifications:
| Item No.: | BH-M001-1000 |
| Min/Max Gap: | 3mm to 14mm |
| Finish: | Clear Anodised |
| Fixing: | Concealed, Fixed by the side plate from both side |
| Seals: | Silicone Rubber Sealing Strips |
| Fixed Part: | Stainless steel side plate with screws |
| Length: | 1000mm |
| Other length can do: | Length can do custmized, from 250mm to 1500mm, |
| Length can be cutted: | 1000mm - can be cutted to 900mm |
Pictures:
Other similar items for reference:
Production line:
